I designed and 3D-printed these mounts and produced them using Grey PLA+ and Space Blue ASA filaments. I use PLA+ for all of my GoPro and accessories that I use.
The Grey PLA+ will work perfectly fine for night time use. It will work during the day in direct Sun/UV light, however it will break down over time.
Each Unit comes with Two stainless steel 3mm washers and Two stainless steel M3-.50×8 screws. You Must install the 3mm washer under the head of the screw. This will ensure the screw does not exceed the recommended depth.
The Space Blue ASA is designed for everyday outdoor use, including direct Sun light.
Both of these mounts were designed to last. They both have 50% infill and 6 layer wall builds along with 1.8mm top and bottom layers. I have been using my Grey PLA+ mounts for over a year now with no issues. You can see in my videos, I use them rain or shine.
**THIS IS THE 3D PRINTED MOUNT ONLY** DOES NOT INCLUDE MeLe**
Each unit sold will help fund a new Solar imaging setup.
I designed and 3D-printed these mounts and produced them using Grey PLA+ and Space Blue ASA filaments. I use PLA+ for all of my GoPro and accessories that I use.
The Grey PLA+ will work perfectly fine for night time use. It will work during the day in direct Sun/UV light, however it will break down over time.
Each Unit comes with Two stainless steel 3mm washers and Two stainless steel M3-.50×8 screws. You Must install the 3mm washer under the head of the screw. This will ensure the screw does not exceed the recommended depth.
The Space Blue ASA is designed for everyday outdoor use, including direct Sun light.
Both of these mounts were designed to last. They both have 50% infill and 6 layer wall builds along with 1.8mm top and bottom layers. I have been using my Grey PLA+ mounts for over a year now with no issues. You can see in my videos, I use them rain or shine.
**THIS IS THE 3D PRINTED MOUNT ONLY** DOES NOT INCLUDE MeLe**
Each unit sold will help fund a new Solar imaging setup.
